General - Kenwood TK-3301 Service Manual

TK-3301
Document Copyrights
Copyright 2009 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced tech ni -
cians familiar with similar types of commercial grade com-
mu ni ca tions equipment. It contains all required service
in for ma tion for the equipment and is current as of the pub-
lication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are is sued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment in for ma-
tion, the full part identifi cation number should be in clud ed.
This applies to all parts : components, kits, or chassis. If the
part number is not known, include the chassis or kit number
of which it is a part, and a suffi cient description of the re-
quired component for proper identifi cation.
Destination
E,T
2
Number of CH Channel No.
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
16 channel
CH9
CH10
CH11
CH12
CH13
CH14
CH15
CH16
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.

GENERAL

PERSONAL SAFETY
The following precautions are recommended for personal
safety:
• DO NOT transmit until all RF connectors are verifi ed se-
cure and any open connectors are properly terminated.
• SHUT OFF and DO NOT operate this equipment near
elec tri cal blasting caps or in an explosive atmosphere.
• This equipment should be serviced by a qualifi ed tech ni -
cian only.
SERVICE
This transceiver is designed for easy servicing. Refer to
the sche mat ic diagrams, printed circuit board views, and
align ment procedures contained within.
Frequency
446.00625MHz
446.09375MHz
446.03125MHz
446.06875MHz
446.04375MHz
446.01875MHz
446.08125MHz
446.05625MHz
446.00625MHz
446.09375MHz
446.03125MHz
446.06875MHz
446.04375MHz
446.01875MHz
446.05625MHz
446.08125MHz
Signaling RF power output
94.8Hz
88.5Hz
103.5Hz
79.7Hz
118.8Hz
123.0Hz
127.3Hz
85.4Hz
0.5W
107.2Hz
110.9Hz
114.8Hz
82.5Hz
D132N
D155N
D134N
D243N