AEG Electrolux 68031 K-MN User Manual page 17

Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5 se-
conds another acoustic signal
sounds
Display is switching between
two heat settings
lights up
lights up
and number are displayed
If you are unable to remedy the problem by following the above suggestions, ple-
ase contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by qualified service engi-
neers. Considerable danger to the user may result from improper repairs.
3
If the appliance has been operated incorrectly, the engineer's visit will be chargeable,
even during the warranty period.
Problem
The control panel is wholly or
partly covered by objects.
The cooking zone was only on
for a short time and is there-
fore not hot
One or more sensor fields have
been covered for longer than
10 seconds
The On/Off sensor field has
been covered up, e.g. by a
cloth
Power management is redu-
cing the power of this cooking
zone
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom of
the cookware is too small for
the cooking zone
Overheating protection for the
cooking zone has been trigge-
red
Automatic switch-off has
been triggered
Electronics fault
Possible cause
What to do if ...
Remedy
Remove objects.
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Uncover sensor field
Do not place any objects on
the control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch appliance off. Switch
appliance on again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the cus-
tomer service department
17