Radio Shack PRO-162 User Manual page 32

systems" and "programming a fleet map").
Why isn't my scanner acquiring a data channel?
SQUELCH is not correctly adjusted for trunk scanning. Adjust squelch for trunk scanning.
See "setting squelch for the trunking mode".
Why is the frequency used for the data channel missing?
Press SCAN to search for the data channel (see "programming trunked frequencies").
Why am I missing replies to conversations?
The system you are trying to track is a Type I system, and the scanner is set to scan Type II
systems. Set the scanner to receive Type I trunked frequencies. See "scanning type I and
hybrid trunked systems".
The selected fleet map is incorrect. Try another preset fleet map or program your own fleet
map (see "scanning type I and hybrid trunked systems").
Enter all of the trunk's frequencies: see "programming trunked frequencies".
How do I reset my scanner?
If the scanner's display locks up or stops operating properly, you might need to reset the
scanner.
Caution: This procedure clears all the information you have stored in the scanner. Before
you reset the scanner, try turning it off and on to see if it begins working properly. Reset the
scanner only when you are sure it is not working properly.
1. Turn off the scanner.
2. While holding down 2, 9 and PSE, turn on the scanner. " Initializing... Please wait" for
about 5 seconds as the scanner clears its memory.
Note: Do not turn off the scanner again until "Initializing... Please wait" disappear.
Otherwise, the scanner might not clear its memory properly.
Follow these steps to restore the 150 preprogrammed frequencies stored in the private
bank.
1. Make sure your scanner is turned off.
2. Press 3 and ENT/PGM simultaneously while turning on the scanner. After several
seconds, the scanner restores the frequencies.
FCC notice
Your scanner might cause radio or TV interference even when it is operating properly. To
determine whether your scanner is causing the interference, turn off your scanner. If the
interference goes away, your scanner is causing it. Try the following methods to eliminate
the interference:
• move your scanner away from the receiver
• connect your scanner to an outlet that is on a different electrical circuit from the receiver
• contact your local RadioShack store for help
Note: Mobile use of this scanner is unlawful or requires a permit in some areas. Check the
laws in your area.
32