Radio Shack PRO-162 User Manual page 21

4. Press or to select the next channel in the bank.
5. Repeat from step 2 until you enter all the desired frequencies in that bank.
Notes:
• If you enter an invalid frequency (outside the selected range), the scanner beeps, then
Invalid Freq. appears. If this happens, press CL to clear the frequency, and then repeat the
entry.
• For EDACS (Ed) and LTR systems, you must enter the frequencies in logical channel
number (LCN) order.
• If you try to enter a duplicate frequency, the scanner beeps and the channel which was
previously stored appears
6. Press SCAN to begin scanning for the trunk's data channel and scan conventional
frequencies at the same time. As the scanner looks through the frequencies, you see them
on the display. When the scanner finds the controlling data channel, the scanner begins
trunking.
programming trunked banks
Follow these steps to select and program trunk bank mode.
1. Press TRUNK in conventional programming mode to go to Program Trunk Bank Mode
2. Press or to select the desired trunked system.
Note: List of trunked systems as follows:
You See
MOT 800
MOT 800 CUSTOM
MOT 900
MOT VHF
MOT UHF
EDCS
EDCS SCT
LT
NON TRUNK
Notes:
• MOT 800 CUSTOM, MOT VHF, MOT UHF require programming of a Base, Spacing
Trunk System
Motorola
Type I, Type II and Hybrid
800 MHz frequencies
Motorola
Type I, Type II and Hybrid
800 MHz frequencies Custom
Motorola
Type II,
900 MHz frequencies
Motorola
Type II,
VHF(136-174 MHz) frequencies
Motorola
Type II,
UHF (406-512 MHz) frequencies
EDACS Wide Band: 9600 baud
EDACS Scat
LTR
No Trunk
21