Ltr Talk Groups; Scanning The Talk Group Id Lists; Priority Talk Group Id Scanning - Radio Shack PRO-162 User Manual

1. Enter the agency number you want to store. Press •/DELAY to enter the dash.
2. Press ENT/PGM. Or you can program all the talk group numbers for one fleet of an
agency.
3. Enter the agency number.
4. Press •/DELAY to enter the dash.
5. Enter the fleet number.
6. Press ENT/PGM. Remember the AFS format allows you to enter full or partial EDACS
IDs for powerful flexibility in all modes. The scanner defaults to AFS talk group displays for
EDACS only.

LTR talk groups

Users on an LTR system are assigned to specific talk groups, which are identified by the
radio as a six-digit number. The number is in the form AHHUUU, where:
A = Area code (0 to 1)
H = Home repeater (01 through 20)
U = User ID (000 through 254)
To enter an LTR ID:
1. Enter the area code.
2. Enter the home repeater number.
3. Enter the Use ID you want to store.
4. Press ENT/PGM.
Note: To clear a stored ID while entering an ID, press 0 and ENT/PGM successively, then
start over.

scanning the talk group ID lists

Press SCAN to begin scanning the lists you have stored.
To remove a scan list from active scanning, use the number keys to enter the scan list's
number. The scan list number turns off, and the IDs in that list are not scanned.
Note: One of the ten scan lists must always be active. You cannot remove all of them.
To restore a scan list to active scanning, use the number keys to enter the number of the
list again.

priority talk group ID scanning

You can assign a priority to a favorite ID so during scanning the scanner checks that ID
more frequently than the others in the list. Each of the ten memory locations reserved for
storing lists (see "using talk group ID lists") can have only one priority ID, and the ID
assigned that priority in List 1 has the highest priority of all.
To assign a priority to an ID, press and hold PRI for 2 second in Program Talk Group ID
mode. P appears.
To turn priority ID scanning on or off, repeatedly press PRI during ID scanning in close
mode operation. See "searching a trunked bank".
PRI appears when priority scanning is turned on.
Note: Priority ID scanning does not operate when priority IDs are locked out. See "locking
27