Boiler Assembly; Burner Base Assembly General Instructions - Smith Cast Iron Boilers GB300 Installation & Operating Manual

Natural or propane gas boiler
Table of Contents

Advertisement

GB300 BOILER INSTALLATION AND OPERATION INSTRUCTIONS

BOILER ASSEMBLY

Locate the boiler installation site based on the guidelines
set forth in the previous pages. A full concrete block
foundation is recommended to protect the boiler from
moisture and debris. Use solid blocks to support the boiler
and hollow blocks for the rest, Figure 1. Align the hollow
blocks so air can flow through them.
WARNING: Never install a GB300(S,W) boiler on
top of combustible flooring! Failure to comply
with this warning may result in a fire causing
property damage, severe personal injury or
death!

Burner Base Assembly General Instructions

WARNING: The burner base must be assembled
as outlined below. Do not make substitutions for
the hardware or materials supplied for the burner
base assemblies. Failure to comply with this
warning may result in property damage, severe
personal injury or death!
Check the contents of the burner base cartons against
the enclosed packing list to ensure that all of the required
parts are present. If they are not, contact your Smith Cast
Iron Boiler distributor or contact the Smith Customer
Service Department.
The burner base panels are factory insulated to simplify
field assembly of the burner base.
Box 63273, Burner Base Side Panels & Brackets,
contains the left & right burner base side panels, manifold
brackets and the jacket brackets, Figure 3.
Figure 3
Burner Base Box 63273
A box with a number from 63265 to 63272, Burner Base
Panels Less Sides, contains the burner base front and
rear panels and the burner base baffle, Figure 4.
Figure 4
Burner Base Box 63265 to 63272
The 5/16 stainless steel nuts and bolts used to assemble
the burner base panels are supplied in the X1 box, that
has a number from 72700 to 72707 on it, Figure 5.
Use care not to damage or dislodge the ceramic
insulation board on the base panels during assembly.
WARNING: If any of the burner base insulation
panels are broken or damaged they must be
replaced with factory supplied panels. Failure to
comply with this warning may result in property
damage, severe personal injury or death!
Figure 5
Page 11
X1 Box 72700 to 72707

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents