iDevices Outdoor Switch User Manual page 6

iDevices®
Switch and
idevicesinc.com/support, or give us a call Monday-Friday from 8am-8pm EST.
4.1 Factory Reset
To reset the unit to its factory condition, hold down the button for 10 seconds,
the unit will flash red and the button can be released. The LED will then flash
white, and then restart the pairing sequence with a fast blue blink.
4.2 I'm experiencing issues with the iDevices®
Connected app
The iDevices® Connected app requires iOS 8.1 or greater.
4.3 I don't have a device to pair to my Outdoor Switch,
can I still use it?
You will have the ability to manually turn the Outdoor Switch on and off using
the button located on the side
4.4 Light Bar Color Codes
The iDevices® Outdoor Switch uses the Light Bar LEDs to indicate the status or mode
of the Outdoor Switch during and after initial setup. Typically the LEDs are only used
when there is no other means to inform the user of the status of the Switch.
The following table summarizes the Outdoor Switch modes and LED status states.
Mode
Pairing
Pairing Expired
Pairing Restart
Pair Set Up Mode
WiFi Link Up
WiFi Link Down
it's capabilities,
Description
The accessory is waiting for the handset to configure the
accessory's WiFi. The LEDs flash blue.
Pairing mode has expired and the user must press the button
(>3 seconds) to reenter Pairing mode. The LEDs slow flash
blue.
After the >3 second hold the user needs a visual to know they
can take their finger off the button to re-enter Pairing mode.
The accessory is waiting for the handset to initiate and complete
pair-setup through either WiFi or BLE. The LEDs are solid blue.
When the accessory joins a WiFi network (i.e. the link is up) the
LEDs fast flash green for a second.
When the accessory has lost the connection to the WiFi network
please visit our
Outdoor Switch
support site at
v1.0