Visi Mobile Cuff Module - Sotera VISI User Manual

9.5 ViSi Mobile Cuff Module

Problem
Cuff Module cable is too short to
Plug into Monitor
No NIBP measurement
NIBP measurement doesn't
match an auscultatory
measurement
Potential Cause
Monitor is oriented in the wrong
direction.
Cuff Module is on the arm
opposite the Monitor.
Battery charge is too low.
Cuff Module not Plugged
securely into the Monitor.
Not set up for automatic
measurements.
The time from the last
measurement exceeds the period
of time to display a
measurement.
Disposable Cuff was touched
during inflation.
Disposable Cuff not placed
correctly.
Measurements were not taken at
the same time.
Measurements were taken on
different arms.
Different size cuffs were used.
Both arms were not at the same
level when the BP was
measured.
Disposable cuff was touched
during inflation.
ViSi Mobile Cuff Module
Solution
Make sure that the flat end of the Monitor
is oriented towards the arm.
Place the Cuff Module on the same arm
that the Monitor is on.
Replace the Cuff Module.
Make sure that the Cuff Module is
Plugged securely into the Monitor.
From the NIBP Settings screen, select an
automatic interval.
Initiate a measurement from the Vital
Signs screen.
Avoid touching the ViSi Mobile
Disposable Cuff during inflation as this
may disrupt the measurement.
Ensure Disposable Cuff is placed onto the
patient's arm correctly. Line up the
arterial line as indicated on the
Disposable Cuff.
Measurements are taken at the same time.
The BP in both arms is the same,
sometimes there is a difference between
arms.
Ensure the BP cuff size is the same on
both arms, and the correct size for the
arm.
The arms are positioned at the same level
relative to the heart.
Avoid touching the ViSi Mobile
Disposable Cuff during inflation as this
may disrupt the measurement.
153