Call Waiting (Network Service); Settings For Call Diverting - Nokia 6600 User Manual

r1013_en.book Page 24 Tuesday, September 2, 2003 8:07 AM
Y o u r p h o n e
Transfer is used to connect an incoming call or a call on hold with an
active call and to disconnect yourself from both calls.
Send DTMF is used to send DTMF tone sequences, for example,
passwords or bank account numbers.
Note: You may not have all of these options. Contact your service
provider for more details.
1. Key in the digits with
tone, which is transmitted while the call is active. Press
repeatedly to produce: *, p (inserts a pause of approximately two
seconds before, or between DTMF characters.), and w (if you use this
character, the remaining sequence is not sent until you press
again during the call). Press
2. To send the tone, press OK.

Call waiting (network service)

If you have activated the Call waiting service, the network will notify
you of a new incoming call while you have a call in progress.
1. During a call, press
on hold.
To switch between the two calls, press Swap.
2. To end the active call, press .

Settings for call diverting

When this network service is activated, you can direct your incoming
calls to another number, for example, to your voice mailbox number. For
details, contact your service provider.
Go to Menu→ Tools→ Settings→
• Select one of the divert options, for example, select
voice calls when your number is busy or when you reject incoming
calls.
• Select Options→ Activate
the divert setting off, or
activated or not.
• To cancel all active diverts, select Options→
24
- . Each keystroke generates a DTMF
to produce #.
to answer the waiting call. The first call is put
Call divert.
to set the divert setting on,
Check status to check whether the divert is
Cancel all
Send
If busy to divert
Cancel to set
diverts.