Reversing The Door - Smeg SW Range Instruction Manual

Reversing the door

The door can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back with the
door uppermost.
6. Loosen lock nut with the fork wrench
enclosed and move the pin.
10. Remember to pull the pin in the door
closer towards the side before fitting
the door..
15. After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully
heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!
2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was fitted.
4. Lift off the door and lay it aside.
7. Remove the lower hinge. Rotate the
hinge through 180° and refit it on the
opposite side of the appliance.
8. Refit the kick plate
11. Refit the door.
12. Fit the upper hinge.
7
5. Remove the kick plate by pulling it
outwards and upwards.
9. Remove the door closer and refit it on
the opposite side.
13. Remove the door handle and refit it on
the opposite side. Refit the caps.
14. The appliance must be allowed to
stabilise in an upright position for at
least 1 hour before being switched on.
GB