Vax Blade TBT3V1B1 Let's Get Started page 8

Getting started
Fixing the wall bracket
Fully assemble
the vacuum.
Holding the wall bracket
firmly in place, carefully
lift and remove the
vacuum away from
the wall bracket.
Slot the wall bracket through the groove
and lift upwards into position.
Using a pencil make
a small mark for
each screw.
Use both screws and wall
plugs to secure the wall
bracket to the wall. Place
covers over the screws.
Choose a position where
you would like to keep the
vacuum stored, preferably
near a mains supply. With
the wall bracket attached,
stand the vacuum close
to the wall, in the upright
position with the Powered
Head flat on the floor.
Firmly press the vacuum
handle into the wall
bracket to secure.