Care And Maintenance - Britax STEELCRAFT PC8343 SERIES Manual

CARE & MAINTENANCE
• To prolong the life of your stroller keep it clean and do not leave
it in the direct sunlight for extended periods of time.
• Removable fabric covers and trims may be cleaned using warm
water with household soap or mild detergent. Allow it to dry fully,
preferably away from the direct sunlight.
• Non removable fabric covers and trims may be spot cleaned
using a damp sponge with soap or a mild detergent. Allow it to
dry completely before folding or storing it away.
• In some climates the covers and trims may be affected by mould
and mildew, to help prevent this occurring, do not fold or store
the product if it is damp or wet. Always store the product in a
well ventilated area.
• When using your stroller at the beach - completely clean
your stroller afterwards to remove the sand and salt from the
mechanisms and wheel assembly. Sand and salt will cause
premature wear and corrosion.
• If there are compression marks on the tyres - Use a domestic
hair dryer to gently warm (DO NOT OVERHEAT) the tyre and
the compression marks should slowly disappear.
• Always check parts regularly for tightness of screws, nuts and
other fasteners - tighten if required. To maintain the safety of
your nursery product, seek prompt repairs for bent, torn, worn or
broken parts. Use only those parts and accessories approved by
Steelcraft.
THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.
www.britax.com.au
23