Smeg FAB28MCUS Instructions For Installation And Use Manual page 19

PROBLEM
Too much ice forming on back wall of
refrigerator section (layer of frost
more than 3/8" - 1 cm thick):
Too much ice forming in freezer
Front of cabinet hot to the touch
Instructions for the User
POSSIBLE CAUSE
- Cooling temperature
device set too high (meaning
lower temperature
appliance);
- door opened often or for long
periods;
- inside temperature
thermostat set on too low a
temperature;
PROBABLE SOLUTION
regulator - Turn the regulator to a lower
setting (1-2) to increase the
inside the temperature inside the appliance
slightly;
- check
providing an airtight seal;
- open the door less often and for
shorter times;
- rise in atmospheric temperature
and humidity;
- do not place hot food or drinks
inside the refrigerator;
setting - Turn the regulator to a lower
setting (1-2) to increase the
temperature inside the appliance
slightly;
- check
providing an airtight seal: If they
are cracked, try to soften the
gasket by pulling it with one hand
and sliding your closed fingers
along the inside;
- open the door less often and for
shorter times;
- rise in atmospheric temperature
and humidity;
- do not place hot food or drinks
inside the freezer;
- the refrigerator
normally. Inside the cabinet there
is a
designed to restrict the formation
of condensation in the area where
the door gasket closes.
that the gaskets
that the gaskets
is operating
surface cooling system
are
are
21