Trunk Release; Auxiliary Outputs; Temperature And Battery Query; Cancelling Reservation Mode - CompuSTAR 2W901R-SS User Manual

General System Functions

Cancelling Reservation Mode

Reservation mode will be cancelled for the following reasons;
You did not activate the parking brake prior to turning off the ignition.
You released the parking brake after the key was removed from the ignition.
You entered valet mode, opened the vehicles door, hood, trunk or set off the alarm.
Reservation Mode Settings
Reservation mode settings can be programmed with Option 1-6. It is recommended that reservation mode settings are programmed by your local authorized
Firstech dealer.
Default1 : Locks doors when reservation mode is set.
Option2 : Hold Key/Start button to initiate Reservation Mode
Option3 : Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicle's rear doors, trunk or hatch prior to the system setting reservation and passively locking/arming.
Hold the Trunk button for 2.5 seconds to release the trunk or hatch. If you are in range, the remote will beep twice, trunk icon
illuminate and "TRUNK OPEN" will scroll across the screen indicating that the trunk release command has been successfully
transmitted.
IMPORTANT: Trunk release is an optional vehicle feature that may require additional parts and labor.
By Firstech, LLC 24
You pressed the foot brake after the key was removed from the ignition.
General System Functions
Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding
moon roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer
can set these outputs up accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts and can be rather
labor extensive.
Tap the Function button for a half second followed by the Trunk button
half second followed by the Key/Start button to trigger auxiliary output 2. The remote will beep once, parking lights flash, and "AUX TRIGGER
1 or 2" will scroll across the screen, indicating that the auxiliary output(s) have been triggered.
By default, the system is in secure auxiliary mode, which requires you to tap the Key/Start button
or 2. To turn off secure auxiliary, ask your authorized Firstech dealer to turn on Option 4-5 to setting II.
When in range of your vehicle, the remote will display the vehicle's temperature and vehicle battery voltage upon tapping the Key/Start
button . The temperature will be displayed after tapping the Key/Start button
second time within four seconds to display the vehicle's battery voltage.
If you tap the Key/Start button and you do not get any response from the remote, the remote pager is most likely out of range to receive
commands. If you tap Key/Start button and the remote reads "FAIL" then your temperature sensor is not installed or may be malfunctioning.
to trigger auxiliary output 1. Tap the Function button for a
for a half second prior to triggering auxiliary 1
for a half second. Tap the Key/Start button a
25 By Firstech, LLC