Advertisement
Make sure you have a clear space, remember when finished and in place you need access to check your build and
able to pull the shower out for servicing or should you have the need to replace anything!
Take the shower tray and remove all the protective wrapping and fit the waste. If you purchased the fitting kit it is
possible this may have already been fitted in the tray hole yet please note this is only for transportation reasons
therefore you will still need to ensure the correct sealing and alignment is carried out. In the side of the waste
supplied in the optional fitting kit you will notice a spigot not seen on an ordinary waste. In most cases this is blanked
yet should you have a steam version you need to gently drill this out as this item is for the steam generator drainage
Now please level the tray by firstly placing the tray in its final location and then using a spirit level, adjust the tray feet
accordingly. Once you are happy with the levelling of the tray, you can pull it out to begin the main construction.
TO START
and will be connected in the instructions later.
www.insigniarange.com
Attach the uprights to the top and bottom curved rail using
the ST35 screws. The end with the groove is designed to
The screw head needs to bypass the OUTER hole. If this
Step 1
sit on the tray, with the flat end connecting to the roof.
Please note the 'U' shaped channel is meant to face
inwards to allow the glass to fit correctly.
(Insignia logo on top rail)
PLEASE NOTE
does not occur please bore out the outer hole only by
about 2-4mm
Last Modified: 07/10/2015
09
Advertisement
