Advertisement
www.insigniarange.com
Last Modified: 07/10/2015
Step 2
Take the 2 x pieces of flat side glass and run the plastic seal down 1
side of each piece and cut to length if required.
Step 3
Align the 2 x side glass panels with the rubber seal into the
glass frame as shown below and push tightly in to position.
Once both panels are tightly in place you can secure the outer
edges of the glass in to position using the glass retaining clips
(PRC20) as shown in the image. To do this simply align the
clips tight up to the glass and using screw type ST13 screw in
to position. Do this for all 4 clips (2 x top and 2 x bottom)
10
Advertisement
