Features & Specifications The K2579 is a basic timer with relay output for time intervals of up to 15 minutes. Set the desired delay with the trimmer. The maximum delay can easily be lengthened and the timer can be stopped and restarted at any time.
Assembly hints 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project successful. Read them carefully. 1.1 Make sure you have the right tools: • A good quality soldering iron (25-40W) with a small tip. •...
Page 5
REMOVE THEM FROM THE TAPE ONE AT A TIME ! DO NOT BLINDLY FOLLOW THE ORDER OF THE COMPONENTS ONTO THE TAPE. ALWAYS CHECK THEIR VALUE ON THE PARTS LIST!
Page 6
Construction 1. Diode. Watch the polarity ! 3. IC socket. Check the 6. Transistor position of the notch! T1 : BC547B D1 : 1N4148 D... CATHODE 7. Electrolytic Capacitor. IC : 8p. Watch the polarity ! 2. Resistor 4.
Page 7
Construction 9. Push buttons SW1 : START SW2 : STOP 10. Relay RY : VR15M121C RY... 11. IC. Check the position of the notch! IC : NE555...
Connection example 12. Connection example 12V DC 300 mA Snubber network* 100E/1W B or C 220nF/400V *see hook-up and use...
Page 9
Hook-up and use 13. Hook-up and use Connect the unit with a 12VDC regulated power supply as shown in the example. Turn the trimmer all the way counterclockwise. Push the START button. The relay will be activated momentarily. ...