Cargo Bed (Select Models) - Snapper 360Z Zero Turn Rider Operator's Manual

Cargo Bed (select models)

The cargo bed is designed to carry up to 50 lbs (22,7 kg).
Slots in the rear of the bed will accommodate a 2 x 4 or 2
x 6 to help secure loads during transport.
DANGER
Amputation hazard
Rotating blades cut off arms and legs. Do not carry
riders (especially children) even with the blades off.
They may fall off or return for another ride when you
are not expecting it.
DANGER
Loss of control and roll-over hazard
Operating with loads in the cargo bed greater than 50
lbs can be hazardous and cause loss of control and
roll-overs.
The cargo bed can be raised to access the engine com-
partment without removing it. First, raise the seat (A,
Figure 13). Then pull up firmly on the rear of the bed (B).
When lowering the bed, press down firmly to secure the
rear of the bed in place with the locking clips (D).
To remove the cargo bed, remove the pins (C, Figure 13)
securing the front of the bed to the rider frame. Pull up
firmly on the rear of the bed to release the locking clips
(D), then lift and remove the cargo bed from the rider.
CAUTION
To avoid injury, assistance is required when
removing or installing the cargo bed.
To install the cargo bed, position the bed over the engine
compartment, aligning the holes in the front of the bed
with the holes in the frame brackets. Install the pins (C,
Figure 13) into the holes. Then lower the rear of the bed,
pressing down firmly to secure with the locking clips (D).
CAUTION
To avoid injury, assistance is required when
removing or installing the cargo bed.
20
B
C
A
D
Figure 13