Advertisement
Step 2
TQ03
1
Install two posts at the rear cor-
ner of building by removing the two
fasteners in the framework. Interlock
the two posts and telescope them to
the proper length between the upper
and mid wall frames. Tabs on ends
of posts go behind frames. Reinsert
top and bottom fasteners. Fasten
posts together using a bolt and nut
at the center of posts.
2
Install the next two posts at either
26 3/8", 27 3/8" or 28 3/4" dimension
(depending on your building) toward
the front and remove the two fasten-
ers as before. When complete, repeat
procedure on the opposite side of
building in the same manner.
REMOVE AND REINSERT
FASTENER
FOR BUILDINGS WITH NO MID WALL FRAME:
Install posts in the same manner. Using hole in bottom tab on post as a guide,
drill 1/4" diameter hole through side wall panel and fasten with a bolt and nut.
26 3/8" (67 cm)
27 3/8" (70 cm)
28 3/4" (73 cm)
POST 8225
TAB
REAR
FRONT
REAR
3
Advertisement
