(Head Lamp Level'g Device) Circuit - SSANGYONG Actyon 2006 Manual

0-68 7340-03
3) CIRCUIT DESCRIPTION
(1) OPERATION AND FUNCTION
A. Sunroof Sliding Operation
▶ Open
To fully open the sunroof, briefly rotate the sunroof switch clockwise (OPEN direction) with
the sunroof closed. To partially open the sunroof, rotate and hold the sunroof switch until it
reaches at the desired position.
▶ Close
To fully close the sunroof, briefly rotate the sunroof switch counterclockwise (CLOSE
direction) with the sunroof open. To partially close the sunroof, rotate and hold the sunroof
switch until it reaches at the desired position.
B. Sunroof Tilting Operation
▶ Tilt-up
To tilt-up the sunroof, rotate the sunroof switch counterclockwise (CLOSE direction) with
the sunroof fully closed.
▶ Tilt-down
To tilt-down the sunroof, rotate the sunroof switch clockwise (OPEN direction) with the
sunroof tilted-up.
C. Anti-trap Function
To prevent any body parts from being trapped by the sliding sunroof, an Anti-Trap function
automatically opens the sunroof when an object is trapped.
However, if the force against the sunroof is less than the specified value, the Anti-Trap
function doesn't operate.
CIRCUIT
ACTYON 2006.03
(2) RESETTING OF SUNROOF CONTROL UNIT
A. To prevent any parts damage and personal injury, the sunroof setting is canceled
- When the battery voltage is disconnected, the fuse is blown, or the abrupt voltage drop
occurs due to old battery while operating the sunroof.
- When an undesired cancellation occurs due to mistake by a technician.
- When parts damage, shorted circuit, or electric leakage occurs.
- When keeping the sunroof switch at "OPEN" position.
B. Symptoms when the sunroof setting is canceled
- The one-touch operation cannot be activated.
- The sunroof is tilted even after completion of closing operation when closing it.
- The sunroof opening and tilting level is significantly low.
- The sunroof does not operate properly when operating the sunroof switch.
C. [0] point reset of sunroof
- Close the sunroof with the sunroof switch and keep the position for approx. 10 seconds.
If the [0] point setting is successfully completed, the sunroof should be properly opened
from this position.
- Check if the sunroof is fully closed. Tilt the sunroof with the sunroof switch and keep it
at the position for 10 seconds ([0] point setting).
- Close the sunroof with the sunroof switch.
D. Checking after reset
- If the sunroof does not operate properly, check the power supply system.
- If the sunroof does not operate or operates only during the switch operation even the
power supply system is in normal conditions, check if the ground circuit of switch is
securely tightened and reset the sunroof system again.