Table of Contents
Advertisement
Getting Started
WARNING: When using this device, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
Do not use this product near water, for example, near a bathtub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near
a swimming pool.
Avoid using this product during an electrical storm. There may be a
remote risk of electric shock from lightning.
1
Attach the stand to the rear of the Hewlett-Packard
MediaSmart Frame100 or HP MediaSmart Frame
130 by screwing it into the threaded hole in the
back of the frame. When the picture frame is in the
horizontal position, the threaded hole is at the lower
right as you face the rear of the unit.
2
Connect the power cord into the DC input of the
picture frame and plug the adapter into a power
outlet.
3
Activate the preinstalled battery in the remote
control by pulling out the tab.
HP MediaSmart Frame User Guide
1
Advertisement
Table of Contents
