GE GLE12HSLSS Owner's Manual & Installation Instructions page 19

Accessory Installation Instructions
INSTALLING IM4D ICEMAKER KIT
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
ELECTRICAL
SHOCK HAZARD
To eliminate the
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding.
YOU WILL NEED
screwdrivers
PREPARE THE REFRIGERATOR
remove the cover for the
icemaker power supply
socket.
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF.
Power
Switch
(Appearance may vary)
INSTALL THE ICEMAKER FILL CUP
icemaker fill cup (13) into the icemaker
as shown.
49-60769 Rev. 3
Pliers Sharp knife
Cover for
icemaker
socket
PLUG IN THE ICEMAKER
Plug the icemaker power cord into the socket making
sure the prongs and holes are matched. Press the
plug firmly into the socket.
Lock the plug in place by
clipping the restraints into
each side of the plug. Make
sure the restraints click into
place. Make sure the power
cord is still in the hook on
back of the icemaker.
MOUNT THE ICEMAKER
basket.
hole on the support bracket of the left side upper
assembly fits in the fill cup opening. Hang the
icemaker on the screw and on the L-shaped tab
in front of the supporting bracket. Then drive the
second mounting screw into the support bracket.
support
bracket
L-shaped
tab
Make sure:
The power cord is still firmly in the socket.
fill tube assembly extends into the fill cup
opening at the back of the icemaker. (Check the
rear of the refrigerator to make sure the fill tube has
not been pushed out of the back of the refrigerator).
the uppermost position of the mounting slots on the
icemaker bracket.
SECURELY TIGHTEN THE ICEMAKER MOUNTING
SCREWS.
Hook
Mounting
screws
OFF position.