Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone; Switching Off The Hob - Kuppersbusch KI8820.0 Instructions For Use And Installation

Suitable for induction cooking
32
Operation

4.10 Operating the keys

The controls described here expect the pressing of a (selection)
key to be followed by the pressing of a subsequent key. The next
key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.

4.11 Switching on the hob and cooking zones

1. Press the ON/OFF key
ting 0 appears and a short signal will sound. The controls are
ready for operation.
2. Use the Power setting display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected will light
up.
3. The touch control
afterwards. A power setting will be switched on.
See the section on Worth knowing about the slider (sensor
fi eld)
Press the respective sensor fi eld
setting or to switch on an additional cooking zone.
Important: the stand-by dot of the cooking zone selected must
Stand-by dot
light up.
4. Immediately put cookware suitable for induction cooking onto
the cooking zone. The pan recognition device will activate the
induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and the
symbol
off after 10 minutes for reasons of safety. Please refer to the
Section on pan recognition.
4.12 Switching off a cooking zone
Use the power setting display (as a key) to select a cooking zone.
The stand-by dot of the cooking zone selected must light up.
5. a) Press the sensor fi eld on the far left
b) drag your fi nger to the left across the touch control
c) press the ON/OFF key
off (all the cooking zones are switched off ).
4.13 Switching off the hob
6. Press the ON/OFF key
pective of any settings.
Please note:
The hob will switch off automatically after 10 seconds when all the
cooking zones are switched of manually (power setting 0) and no
key/sensor fi eld is pressed afterwards.
* The Power boost function is activated immediately. See the secti-
on on Power setting.
(approx. 1 sec.) until the power set-
must be activated immediately
.......left Power setting 0.
.......center Power setting 6.
.......right Power setting P*
. If no pot is placed on the cooking zone it will switch
to reduce the power setting to 0
. The entire hob will be switched
. The hob will be switched off , irres-
GB
to change a power
or