Cylinder Setup - Linde MT Tracker BBQ Operating Manual

06
MT Tracker BBQ Operating Manual

Cylinder setup

The cylinder should be kept upright at all times
throughout the installation process. Clean the
bottom of the cylinder of any debris, excess paint,
and rust.
The sensor mounts to the bottom centre of the
cylinder using magnets. The rubber pad between
the magnets must make good contact with the
cylinder, with no contaminants in between and
must be aligned to the bottom centre of the
cylinder.
Check that the cylinder is on a level and flat
surface or otherwise is level with ground. Even
a slight tilt can degrade the quality of the
measurement.
After a short period the LPG will settle and the
readings will stabilize.
Magnet
Rubber pad
Magnet