The Linde Group at the time of purchase. Sensors The Linde Group can not accept liability in respect of any Key Features errors or omissions herein contained or for any loss or...
Ex ia d IIC T4 Gb -4F/-20ºC ≤ ta ≤ 149F/65ºC should be checked periodically with known Baseefa09ATEX0240 The Linde Group, GU2 7XY, UK concentration calibration gas. Failure to check IIIIIIIIII BAR CODE...
Rechargeable batteries can only be replaced people or animals breathing and if the room is by a Linde Group Authorised Service Centre. poorly ventilated concentrations well in excess of 1 000ppm (0.1%) can occur. CO...
Only recharge the battery in a safe (non-hazardous) G-TECTA SG’s shape and design ensures high levels ® area with a Linde G-TECTA SG charger. Failure to ® of user comfort and minimal interference with the comply could invalidate safety certification and may user’s normal work function.
G-TECTA SG – Product Features Note: During the start up sequence, check the ® battery status symbol to ensure you have enough Alarm battery charge to use the instrument. LEDs Calibration Check If the instrument is due for calibration in less than 31 days “CAL xx”...
Instrument Storage Display Menu Options In order to optimise sensor performance and lifetime, The G-TECTA SG menu is displayed when you press ® your G-TECTA SG instrument should be stored in a the mode button twice. There are up to 4 menu ®...
Alarms WARNING The 8 hour TWA alarm cannot be cleared. G-TECTA SG has two instantaneous alarm level ® settings, AL-1 and AL-2. Flammable Over-range Alarm If flammable gas levels exceed 100% LEL, Alarm signals G-TECTA SG locks into alarm and displays “9999” ®...
The logs can be accessed and battery in a safe (non-hazardous) area and with a downloaded by using the G-TECTA SG charger with ® Linde G-TECTA SG charger. Failure to comply could ® PC interface and by using G-TECTA PC software.
If you experience a noticeable reduction in battery neck for additional comfort. life in the instrument, rechargeable batteries Attaching the Chest Harness Plate should be replaced by a Linde Group Authorised The chest harness plate is attached to the Service Centre. instrument by replacing the alligator clip.
Attach the aspirator bulb onto the other nozzle. The Linde Group recommends a bump test each Check the aspirator bulb is attached correctly time the G-TECTA SG instrument is used or issued ®...
Page 12
FAIL, please see the bump test/calibration brands, including Linde, BOC, AGA, Afrox etc. troubleshooting guide or contact The Linde Group. The Linde Group gases supplied for use with your To abort the gas test press the mode button G-TECTA gas detection instrument are specially ®...
G-TECTA PC software.** ® The Linde Group recommends G-TECTA SG is sent ® for full certified calibration at six monthly intervals. This is a zero point calibration rather than a normal zero.
G-TECTA PC Software ® Instrument passes gas Zero not performed Initiate zero on instrument menu test but will not enter from options menu calibration mode Instrument incorrectly configured Re-configure instrument. Send to Linde Group service centre...
G-TECTA SG – PC Interface ® When using a USB adaptor to connect the instrument, follow the procedure below: and PC Software* (i) Before connecting the instrument, G-TECTA PC Software gives the user access to data ® check the available communications ports and event log files, printing reports, reconfiguring available on the G-TECTA PC software...
Display shows empty Battery has no charge Re-charge or replace battery battery symbol If you experience any other issues with the operation of the G-TECTA SG instrument, ® please go to www.g‑tecta.com or contact an Authorised Linde Group Service Centre.
(LEL) Propane 0-100% The Linde Group can advise on particular situations (LEL) Pentane 0-100% and suggest alternative sensors if the instrument is likely to experience extreme conditions.
® sensors and accessories manufactured and sold G-TECTA date of purchase ® by The Linde Group to be free from defects in G-TECTA ® materials and workmanship for the periods listed in the following tables. Damages to any Linde Group...
Page 24
No page or part of this operation manual may be reproduced in any form without written permission of the copyright owner shown above. The Linde Group reserves the right to correct typographical errors. All information is correct at time of going to print.