Troubleshooting Tips - Linde MT Tracker BBQ Operating Manual

Troubleshooting tips

Make sure your cylinder is level. If the cylinder is
sitting at an angle, the surface of the liquid will
also be at an angle, sometimes causing incorrect
readings.
MT Tracker BBQ™ sensor must be located
properly. The black rubber contact pad should be
placed on centre of the cylinder bottom.
If experiencing a reading that looks incorrect
or erratic, sometimes a slight reposition of the
sensor will correct the problem.
If the bottom of the cylinder is dirty or rusty it will
need to be wiped clean of any debris first. Also
the black rubber contact pad on the sensor should
be kept clean.
MT Tracker BBQ Operating Manual
If the cylinder is moving or vibrating it will
degrade the quality of the signal.
Movement of the cylinder can cause the liquid
to slosh, sometimes causing erratic readings.
Readings should go back to normal after a few
minutes.
It's typical to see the level change slightly with
changing temperature. This is a characteristic of
LPG as it boils into gas.
MT Tracker BBQ™ sensor is shipped in sleep mode
to preserve battery life. You must press the Sync
button on the sensor at least 5 times to wake it
up before it will be detected.
017