Table of Contents
Advertisement
TROUBLE SHOOTING
Sander Is Overheating
This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed
air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not apply excessive pressure.
Excessive Sparking Occurs
This indicates worn brushes. This problem is quickly remedied but you should consult your
CLARKE dealer for parts and advice.
Sander Does Not Operate When Switched On
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows
repeatedly, consult your CLARKE dealer.
The Dust Is Not Extracted
Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually caused by
allowing bag to become too full, (remove and empty bag, also clear blockage).
Note :
Ensure sander is switched OFF and isolated from the mains by removing plug from socket.
ACCESSORIES
A wide range of accessories is available from your nearest CLARKE dealer, for further
information, contact your nearest dealer, or telephone CLARKE International Sales
department on 01992 565300
11
Advertisement
Table of Contents
