Installing The Kvm Switch; Pre-Configuration - Belkin OMNIVIEW F1DS104J User Manual

Installing the KVM Switch

Pre-Configuration

Where to Place the KVM Switch
The compact size of the KVM Switch makes it perfect for desktop placement.
Consider the following when deciding where to place the KVM Switch: whether
or not you intend to use the direct-access port selectors; the length of the cables
attached to your keyboard, mouse, and monitor; the location of your CPUs from
your console; and the length of the cables you use to connect your computers to
the KVM Switch.
Cable-Distance Requirements
For PS/2 computers: VGA signals are best retained when transmitted up to 25 feet
(7.6m). Beyond 25 feet (7.6m), probability of video degradation increases with an
increase in distance. For this reason, your PS/2 computer should be placed within
25 feet (7.6m) of the KVM Switch.
For USB computers: USB signals can be transmitted up to 15 feet (4.6m) between
the KVM Switch and the CPU. Beyond 15 feet (4.6m), probability of signal failure
is likely.
Cautions and Warnings
Avoid having cables near fluorescent lights, air-conditioning equipment, or
machines that create electrical noise (e.g., vacuum cleaners).
Single-Switch Installation
This section provides complete instructions for the hardware setup of a single KVM
Switch. (F1DS102J or F1DS104J)
Important Note: Before attempting to connect anything to the KVM Switch or
into your computer(s), make sure that everything is powered off. Plugging and
unplugging cables while computers are powered on may cause irreversible damage
to the computers and KVM Switch. Belkin will not be responsible for damage
caused by these actions.
Cable/model types:
PS/2 and USB models use: VGA/USB/PS/2 combo cable connected to the USB or
PS/2 connector of the host PC
6 6