Juniper TCX1000 Quick Start Manual page 6

TCX1000 Inline Amplifier Quick Start Guide
Figure 5: Connecting an AC Power Cord to an AC Power Supply in a TCX1000-ILA
If the AC power source outlet has a power switch, set it to the off (
4.
NOTE: The TCX1000-ILA powers on as soon as power is provided to the power supply.
Insert the power cord plug into an AC power source outlet.
5.
Repeat the steps for each power supply you are connecting to power.
6.
If the AC power source outlet has a power switch, set it to the on (
7.
Verify that the status LEDs on each power supply are lit green.
8.
If any LED is lit red, remove power from the power supply, and replace the power supply (see "Maintaining the TCX1000-ILA
Power System" in the TCX1000 Inline Amplifier Hardware Guide). Do not remove the power supply until you have a replacement
power supply ready: either power supplies or blank cover panels must be installed in the TCX1000-ILA to ensure proper airflow.
CAUTION: Replace a failed power supply with a blank panel or new power supply within one minute of removal
to prevent chassis overheating.
6
) position.
O
) position.
|
Copyright © 2018, Juniper Networks, Inc.