Panasonic EY7441 Operating Instructions Manual page 16

Cordless hammer drill & driver
Hide thumbs Also See for EY7441:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
1
Line up the alignment marks and
EN
place the battery onto the dock on
the charger.
NOTE:
Not all battery packs display the
alignment mark (F) (on page 2).
2
Slide forward in the direction of the
arrow. [Fig.17
3. During charging, the charging lamp will
be lit. When charging is completed, an
internal electronic switch will
automatically be triggered to prevent
overcharging.
• Charging will not start if the battery
pack is hot (for example, immediately
after heavy-duty operation).
The orange standby lamp will be
Charging will then begin automatically.
4.
slowly once the battery is approximately
80% charged.
LAMP INDICATIONS
(Green)
Turn off
Battery Recycling
ATTENTION:
For environmental protection and recycling of materials, be sure that it is disposed of at
EY971074418.indb
16
]
Charging is completed. (Full charge.)
Battery is approximately 80% charged.
Now charging.
Charger is plugged into the AC outlet. Ready to charge.
Charging Status Lamp.
(Orange)
Left: green Right: orange will be displayed.
Battery pack is cool.
The battery pack is being charged slowly to reduce the load on
the battery.
Battery pack is warm.
Charging will begin when temperature of battery pack drops. If
the temperature of the battery pack is -10°C or less, the
will begin when the temperature of the battery pack goes up.
Charging is not possible. Clogged with dust or malfunction of
the battery pack.
Illuminated
- 16 -
5. When charging is completed, the
charging lamp in green color will turn
off.
6. If the temperature of the battery pack is
0°C or less, charging takes longer to
fully charge the battery pack than the
standard charging time.
Even when the battery is fully charged,
it will have approximately 50% of the
power of a fully charged battery at
normal operating temperature.
7. Consult an authorized dealer if the
charging lamp (green) does not turn off.
8. If a fully charged battery pack is
inserted into the charger again, the
charging lamp lights up. After several
minutes, the charging lamp in green
color will turn off.
9. Remove the battery pack while the
battery pack release button is held up.
[Fig.17
]
Flashing
2018-05-28 10:27:02

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ey7443Ey7940Ey74a1Ey7451

Table of Contents