4. Factory AsteRx2e receiver Settings
The instructions below should be used to reconfigure an G3100 back to PENTAX
Default. This is the #1 method for resolving problems with the G3100's operation, and
should always be executed before contacting PENTAX support.
Reconfiguring the G3100 back to PENTAX Default sets the unit as a Rover,
Message Type: RTCM v3.1, Logged Data Type: SBF. The two ways of accomplishing
factory settings are:
1) Upload appropriate
2) Typing the commands in line-by-line.
[1]
The G3100 model is determined by the serial number found on the bottom of
the receiver.
4.1.
Uploading a script/text file using RxControl
A text file with factory reset commands is included on the CD shipped with each new
G3100 unit. The file can also be downloaded from the PENTAX website:
§
G3100 (2XXXX):
4.1.1. From the RxControl File menu, select "Upload script".
[1]
PENTAX default script using RxControl
G3100 Default Config.txt
Figure 10: Upload Script
Page | 21