Attaching A Carabiner; Calibrating The Touchscreen - Garmin DAKOTA Owner's Manual

Attaching a Carabiner

1. Position the carabiner clip in the
slots on the mounting spine of the
Dakota.
Mounting
spine
2. Slide the clip up until it locks in
place.
To remove the carabiner clip, lift
the bottom of the clip and slide the
carabiner clip off the mounting spine.
Dakota Series Owner's Manual
190-01069-00_0A.indd 37
Carabiner
Carabiner
clip
Calibrating the
Touchscreen
The Dakota screen does not normally
require calibration. However, if the
buttons do not seem to be responding
properly, use the following process.
To calibrate the touchscreen:
1. While the unit is turned off, press
and hold the Power
approximately 30 seconds.
2. Follow the instructions on the
screen until "Calibration is
complete" is displayed.
Appendix
key for

4/17/2009 1:19:12 PM