How To Load Media - Roland TU2-64 User Manual

How to Load Media

CAUTION
CAUTION
CAUTION
VG series,VS series, RS series, VP series, SP-540i/300i, RA-640, RE-640
1.
Pass the media through the printer.


SETUP SHEET
TU
VP series, RS series, SP-540i/300i, RA-640, RE-640 or when selecting [TU] with VG

series, VS series:
Make sure the printer's [PREFEED] and [FEED FOR DRY] menu items are each set to
"DISABLE." (For RS series, RA-640 and RE-640, check [FEED FOR DRY] only.)
For information on how to check or change setting values, refer to the user's manual for the printer.

Load roll media correctly.
Otherwise the media may fall and cause injury.
Roll media weighs about 30 kg (66 lb.). To avoid injury, handle with care.
Never load media that weighs more than 30 kg (66 lb.).
The printer may fail to withstand the weight and topple over, or the media may fall
from the unit.
Dancer roller
Switch on the printer's sub power, and when the screen shown
in the figure appears, press
companying the pull-back operation) or [TU] (not accompanying
the pull-back operation).
[TU2] is available only when you're using the VS series printer.
Move the dancer roller toward the
rear.
Load roll media onto the printer, then
lower the loading lever.
OK
For information on how to perform loading, refer
to the user's manual for the printer.
After loading, check the following points.
 The media is loaded straight.
 All areas of the media are taut.
Not
If the media is slack or crooked, raise the loading
lever and reload the media.
OK
4. Operation
to select [TU2] (ac-
23