RCA COSMAC Operator's Manual page 27

PROGRAMMING INTERFACE TO CSDP (cont'd)
into the time-sharing system, as a file named SAMPLE.
Once this is done, the user calls for activation of the
CSDP program. When CSDP is ready for a command, it prompts
the terminal with the 'DBG' message. By entering the CSDP
command-~A
SAMPLE, TTY CR, the user calls for an assembly
of this file, with listIng and diagnostics printed to the
terminal*. The output he receives is indicated in Figure 4
below.* The COS~~C CODE listed there (the same as that in
the hex program generated earlier) has now been loaded
into the CSDP simulator's memory. After generating the
listing, CSDP again returns with the 'DBG' prompt.
* Refer to the COSr-.~C Software Manual for detailed CSDP
user instructions and an explanation of the assembly
"listing format.
- 21 -