Table of Contents
Advertisement
6. Troubleshooting
The dishwasher is capable of signalling a number of faults through the simultaneous illumination of
several indicator lights, with the following meanings:
FAULT
E1
E3
E4
E5
E6
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
•
•
TECHNICAL DATA
Width
Depth measured flush with the outer edge of
the control panel
Height
Capacity
Water supply pressure
Electrical characteristics
User instructions
Light off
In case of E1, E3 and E4, the washing program must be set again to continue.
In case of E5 and E6, simply open and close the door to continue (once the cause of the fault
has been illuminated).
The dishwasher's anti-flooding system has been activated
(only for models equipped with the "TOTAL ACQUASTOP"
device).
This alarm is triggered in the event of a water leak in the
dishwasher. In such circumstances the technical service centre
must be called.
The dishwasher fails to heat the water.
Repeat the wash program. If the problem persists, contact the
customer technical service centre.
The temperature monitoring system has failed.
Switch the dishwasher off, switch it back on and restart the
washing program.
If the alarm recurs, call the After Sales Service.
The dishwasher fails to draw water.
Ensure the plumbing connections are in order and that the water
supply tap is open.
The dishwasher fails to drain.
Check that the drain hose is not kinked, the siphon is not
obstructed and the filters are not clogged.
Light on
597 ÷ 599 mm
570 mm
from 820 mm to 870 mm
14 Standard place settings
min. 50 – max. 900 KPa (min. 0.5 – max. 9 bar)
See rating plate
DESCRIPTION
Light flashing
45
Advertisement
Table of Contents
