Table of Contents
Advertisement
2.2 - Rear Panels
1
MZX1002
MIXER ZONE
FUSE: T125mAL/250V
~ AC INPUT
230V 50/60 Hz, 16W
2
1. DC 24V INPUT AND LINK OUTPUT Device will be supplied DC 24V through input terminal and supply
to other device through link output terminal.
2. AC INLET This AC inlet allows replacing fuse conveniently. Please make sure the value of fuse before
replacement.
3. CHANNEL INSERT These insert jacks allow connecting external effectors like compressor, limiter,
noise filters. M&L would like to recommend using proper insert cable as below Pig.6
Tip:Output(Send to external device)
Sleeve:Ground
Ring:Input(Return from external device)
4. SUB OUTPUT Sub output channel is prepared for sub amplifier.
5. MAIN OUTPUT Main amplifier will be connected to this output terminal.
6. PRIORITY INPUT Whole other input signals will be muted automatically by priority input signal. This
terminal will be used to evacuation announcement.
7. RECORD OUTPUT This terminal allows recording with tape recorder.
8. LINE INPUTS These line inputs can be connected line level equipments. This device allows connecting
6 balanced(CH1-6) and 4 unbalanced(CH7-10) inputs. Also allow adjusting level with TRIM pot of front
panel to accept variable input sources.
9. MICROPHONE INPUTS This device allows connecting 6 balanced microphone input with acceptable
wide impedance range from 50ohm to 600ohm.
10. PRIORITY SWITCHES These switches allow talk over for MIC channel 1 and 2. All other input signals
except priority input channel are muted when this function is activated during press. MIC channel 1
and 2 have same priority grade as priority input channel during these swithes are pressed.
11. PHANTOM POWER SWITCHES This device supply DC+18V phantom power to use condenser
microphone with MIC1 and 2 channels.
MZX1002
3
4
6
8
5
7
7
10
11
9
Fig.3
Advertisement
Table of Contents
