Panasonic WV-Q169A Operating Instructions Manual page 13

Loosen 4 enclosure fixing screws using the
r
bit (supplied with the camera).
Remove the enclosure from the camera,
and secure the camera using a camera fix-
ing screw.
IMPORTANT:
• Be sure to tighten the camera fixing screw.
Failure to observe this may cause camera
trouble due to camera falling.
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Adjust the angle of the camera with the tilt
t
table, pan table, and azimuth adjustment
ring, and then adjust the viewing angle by
pressing the WIDE or TELE buttons.
Refer to the installation guide of the cam-
era.
Use the driver bit (supplied with the camera)
y
to tighten the screws that secure the cam-
era enclosure and mount the enclosure on
the camera main body.
Hooks for the
decorative
cover x3
Projection
Step 9
Mount the decorative cover on this mount
bracket.
• Align the "I" mark of the decorative cover
supplied with this mounting chassis with
the hook of the mounting chassis, press the
decorative cover against the ceiling, and
rotate the decorative cover clockwise when
viewing it from beneath to secure the
cover.
• Two types of decorative cover are provided.
For WV-SFV631L and WV-SFV611L, use
the one whose diameter of the opening for
the dome cover is smaller. For the other
models, use the one whose opening diam-
eter is larger.
Projections x3
"I" Mark
Decorative cover
13