Parameter Setting - Danfoss GreenCon RC-T2 Installation Manual

Installation Guide
press "
GB
Press " < " or " > " to adjust heating temperature dur
ing first event, press "
to adjust cooling temperature during first event,
press "
Repeat above operation for next 3 events
4. Programming for weekend set up;
After finishing programming of work days, "Sat.Sun"
will appear on screen, repeat above steps to set start-
ing time and temperature on weekends.
From next event, GreenCon will automatically change
setting temperature according to this set up.

9. Parameter setting

Long press "M" for 6 seconds to enter param-
eter setting mode.Then, short press "M" to
select parameter; press
value.
Parameter
P01
P02
P03
10
GreenCon RC-T2/T4
" to confirm;
" to confirm;
Definition
Programming
function On/Off
Timer ON/OFF
Maximum room
temperature
setting
VIE2D22P
" to confirm;Press " < " or " > "
" < " or " > "
Setting range
01: Off；02:5/2
days 4 event
01:ON；02:OFF
5-35°C
Danfoss Heating Solutions
to adjust
Factory
setting
01
01
30°C