Dc Outlet - Mäktig 710035 Owner's Manual

RECHARGING THE BATTERY WITH THE JUMPSTART CLIPS
WARNING: Fire Hazard
Never allow cables' red and black clamps to touch each other or another
common metal conductor. This could cause damage to the unit and/or
create a sparking/explosion hazard.
The connection of the cables to the power source must be positive to
positive (red clamp to battery "+") and negative to negative (black clamp to
battery "-"). A reverse polarity connection may cause damage to the unit
and/or create a sparking/explosion hazard.
To recharge with the jumpstart clips:
1. Ensure that the jumpstart power switch is "OFF".
2. Connect the red positive (+) clamp of the cables to the positive (+)
terminal of power source.
3. Connect the black negative (-) clamp of the cables to the negative (-)
terminal of power source. If the red "Reverse Polarity" LED illuminates,
then reverse polarity has been detected. Correct polarity must be
established before proceeding. Disconnect the jumpstarting clamps
from the vehicle's battery and do the steps 2 and 3 again.
4. Turn on the jumpstart power switch.
5. Turn on the power source to charge the battery.
Features: Input voltage 13.5V, Input current 2A (recommended), not
protected.
7. 12V DC OUTLET
This option allows you to use optional 12V power accessories with the
cigarette lighter plug. Use the portable power outlet for power supply,
fishing and camping trips, extended running for mobile phones,
camcorders, computers and so on by combining your unit with an inverter
provides 110V AC power.
NOTE: There is no 12V cigarette plug with this unit!
9