Page 1
800A JUMPSTARTER OWNER’S MANUAL Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may damage the equipment and result in serious personal injury. Part No 710035...
Keep away from WATER – FIRE - SMOKE! Recharge the unit before using it! TABLE OF CONTENTS CONVENTIONS …………………………………………… 1. INTRODUCTION ………………………..…………….. 2. SCOPE OF DELIVERY ……………………..………… 3. IMPORTANT SAFETY INSTRUCTIONS …………… 4. FEATURES ……………………………………..……… 5. OPERATION …………………..………………..……… 6. RECHARGING …….…………………………..………. 7.
1. INTRODUCTION Congratulations on your purchase of this quality Mäktig product! Easy-to-use and designed for reliable service, this 800A jumpstarter can run many DC appliances whenever you need power for work or play, at home or on the road. The 800A jumpstarter has an internal battery, and is designed to jumpstart vehicles such as SUVs, trucks, and vans.
WARNINGS Before starting the vehicle, be sure that the clamps are connected in the right way and the green indicator light is on. This Jumpstarter contains components that tend to produce arcs or sparks. To prevent fire or explosion, do not operate the Jumpstarter in locations containing batteries or flammable materials, or in locations that require ignition-protected equipment.
Page 5
1. Battery level button – When pressed, you can see the battery level according to the battery level indicators. 2. Battery power level indicators Value of the battery Display mode U<10.5±0.4V Only red LED indicator lights. (10.5±0.4V) <U< (12.5±0.4V) Only yellow LED indicator lights. U>12.5±0.4V Only green LED indicator lights.
12. Jumpstart power switch – It is a manual rotary switch. When you jumpstart a vehicle, you should turn off the switch and the vehicle engine and connect the unit to the vehicle. Then you turn switch. Executing these steps in the right order extremely...
Page 7
WARNING: Fire Hazard Never allow jumpstart cables’ red and black clamps to touch each other or another common metal conductor. This could cause damage to the unit and/or create a sparking/explosion hazard. WARNING The connection of the jumpstart cables to the vehicle’s battery terminals must be positive to positive (red clamp to battery “+”) and negative to negative (black clamp to battery “-“).
8. Remove the red positive (+) clamp and then the black negative (-) clamp from the engine battery. 6. RECHARGING WARNING Do not charge the unit in wet or moist locations because it may cause severe electric shock and injury may result. WARNING Do not charge the unit immediately after any severe discharge or heavy usage.
RECHARGING THE BATTERY WITH THE JUMPSTART CLIPS WARNING: Fire Hazard Never allow cables’ red and black clamps to touch each other or another common metal conductor. This could cause damage to the unit and/or create a sparking/explosion hazard. The connection of the cables to the power source must be positive to positive (red clamp to battery “+”) and negative to negative (black clamp to battery “-“).
8. TROUBLESHOOTING Problem Cause Solution The internal battery in the Jumpstarter jumpstarter is not fully Charge for at least 28 hours can not jump charged start vehicle The jumpstarter’s battery Replace jumpstarter battery has been damaged Accessories connected to Disconnect accessories 12V DC socket Jumpstarter 110V AC charger...