Eaton Crouse-Hinds Series Instruction Manual page 21

INM 4500/4600 Rev 12
DRAFT - 22 March 2018
5 .2 .3 Finishing
Connect individual isolators in accordance with wiring schedules.
Ensure hazardous- and safe-area wiring is segregated into separate trunking or looms
and maintain a tidy installation.
Use an MTL4599 dummy isolator to provide termination and earthing for unused cores
from the hazardous area.
5 .2 .4 Module mounting and removal
Check for the correct orientation of the module then locate it between the latching clips.
Press the module straight onto the backplane. See Figure 5.4.
To remove the module, unclip the latch nearest the CE mark shown on the module label
and rotate the module away from this latch. When the module is unplugged from the
power connector, move the module clear of the other latch and remove it. See Figure 5.5.
Figure 5 .4: Mounting a module onto a backplane
Figure 5 .5: Removing a module from a backplane
13