Classic Eco1 Installation & Operator's Manual page 12

5.3 Switch the machine on :
The machine will now automatically fill and heat, during this process the door
should remain closed, allowing the process to be completed quickly.
5.4 Machine ready to operate :
Depending how your appliance has been commissioned, it may be possible to
start a cycle prior to the 'Machine ready' / 'Water hot' lamp being illuminated,
'Classic' would recommend that you wait for the lamp to be illuminated before
requesting a cycle to commence.
Note !
On the 'DUO' range of appliances, the 'Machine Ready' lamp indicates when the
machine initial reaches its desired temperatures, thereafter the lamp changes
function to a 'Cycle in progress' lamp and will illuminate when a cycle is
requested and during the cycle itself.
5.5 Starting a cycle :
Close the door, then depress the 'Cycle' switch, your appliance will now auto­
matically progress though the cycle, during which time the 'Cycle in progress'
lamp will be illuminated.
5.6 Draining :
During normal operation your appliance will automatically drain away any
excess water.
'Classic' recommends if your appliance is not being used for a prolonged period
of time the machine must be completely drained down
Page 10
Ensure that both the water and electrical supply are
connected and switched on, then depress the 'ON/OFF'
switch located on the fascia of the machine.
To start a cycle, open the door, load the first basket, ensuring that
bottom and top wash arms will rotate freely, on Eco1, Eco2 and Duo2
appliances there are no top rotating wash arms.
At the end of the cycle open the door and remove the basket, then
reload the machine and repeat as required