Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for INVISIBLE FENCE MaxDog Computer Collar
Summary of Contents for INVISIBLE FENCE MaxDog Computer Collar
- Page 1 ™ MaxDog ® Computer Collar Unit Owner’s Manual www.invisiblefence.com...
-
Page 2: Table Of Contents
3. Adhere to all cautions and warnings contained in any Invisible Fence® Brand manual. 4. Do not attempt to service any Invisible Fence® Brand equipment. Refer all service to your authorized Invisible Fence® Brand Dealer. Only your authorized Invisible Fence®... -
Page 3: Components
The MaxDog ™ Computer Collar® unit applies a correction when your pet crosses the boundary of an Invisible Fence® Brand electronic pet containment system. Corrections are used in combination with rewards to alter unwanted pet behavior. Your Invisible Fence® Brand pet containment system will only work when: a. -
Page 4: Operating Guide
Operating Guide The MaxDog Computer Collar Unit ™ ® MaxDog ™ Computer Collar® unit is a patented microprocessor-controlled device, powered by a patented Power Cap® unit. Note: ONLY use the post tightening tool to tighten the correction posts.Use of other tools will void the warranty. -
Page 5: Changing The Power Cap Unit
Replace your existing Power Cap® unit with one supplied via your Power Cap® unit plan. If a fresh Power Cap® unit is not available, contact your Invisible Fence® Brand Dealer for a replacement. Once a replacement Power Cap® unit is installed and the signal... -
Page 6: Troubleshooting Guide
Take the MaxDog ™ Computer Collar® unit off your pet to measure the signal field width. 1. Hold the Invisible Fence® Brand MaxDog ™ Computer Collar® unit so it is parallel to the signal field wire. -
Page 7: Important Warnings
• Signal field wire has a break. • Power is not supplied to the transmitter or power is out. Action • Replace the Power Cap® unit. • Contact your Invisible Fence® Brand Dealer. • Make sure transmitter power supply is plugged in. -
Page 8: Compliance
Compliance US and Canada IC: 2721A-3001055 FCC ID: KE3-3001055 This device complies with Industry Canada rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 9 www.invisiblefence.com...
- Page 10 800-578-DOGS (USA) (865) 777-5404 (International) 400-xxxx ® © 2008 Radio Systems Corporation All rights reserved. www.invisiblefence.com...
Need help?
Do you have a question about the MaxDog Computer Collar and is the answer not in the manual?
Questions and answers