Keypad Settings - LCN 9700 Series Installation Instructions Manual

Settings (except for close speed) for the Middle and Senior Swing Power Operator System are changed using
keypad pushbuttons and an alphanumeric display on the Astro Swing control box (Figure 4-1 and Figure 4-2).
Close speed is changed using dials on the control box (Figure 4-1).
See page 9 and page 10 for directions for changing the values of settings.
!
Adjust the operator for the slowest operation practical in accordance with the latest
revisions of Americans with Disabilities Act, ANSI/BHMA A156.19 (American National
Standard for Power Assist and Low Energy Power Operated Doors), and local codes.
CAUTION: 120 VAC
2.5 A TIME-DELAY FUSE
WARNING: FOR CONTINUED
PROTECTION AGAINST FIRE,
REPLACE ONLY WITH SAME
TYPE AND RATING OF FUSE.
COMPANION
S
L
O
W
CLOSE
SPEED
Close speed dials
Setting display
Setting selection
pushbuttons
Page 8 of 14

4. KEYPAD SETTINGS

MASTER
UP
F S F
A L A
DOWN
S O S
T W T
CLOSE
SPEED
Figure 4-1. Control Box Panel with Keypad
SETTING
UP
DOWN
Figure 4-2. Closeup of Control Box Keypad
CAUTION
SETTING
VALUE
DEFAULT
POWER
: OPENING SPEED
ON
: BACKCHECK SPEED
: BACKCHECK POS.
: HOLD-OPEN DELAY
UP
: LATCH POSITION
: AUTO-REV. CLOSING
: ELECTRIC LOCK
: POWER BOOST
DOWN
: PUSH 'N' GO
: ALTERNATE ACTION
: SAFETY SLOW/STOP
: SLOWDOWN DISABLE
: RESERVED
VALUE
DEFAULT
: OPENING SPEED
: BACKCHECK SPEED
: BACKCHECK POS.
: HOLD-OPEN DELAY
UP
: LATCH POSITION
: AUTO-REV. CLOSING
: ELECTRIC LOCK
: POWER BOOST
DOWN
: PUSH 'N' GO
: ALTERNATE ACTION
: SAFETY SLOW/STOP
: SLOWDOWN DISABLE
: RESERVED
LCN
®
XXXX SWING
XXXX-00
SN: XXXX
WARNING: ALL SPEED
SETTINGS (OPENING,
CLOSING, AND LATCHING)
AND HOLD-OPEN TIME-
DELAY MUST BE FIELD
ADJUSTED TO MEET
LATEST APPLICABLE ANSI/
BHMA STANDARDS.
Keypad
Value display
Reset to default
values pushbutton
POWER
ON
Value selection
pushbuttons
740100-00(5)