Table of Contents
Advertisement
OVERVIEW
OmniView SE Plus Series KVM Switches allow you to control up to a
maximum of 16 computers with one keyboard, monitor, and mouse. They
support PS/2 input devices (keyboard and mouse) as well as VGA, SVGA,
XGA, and XGA-2 video.
It supports both PS/2 and USB output. This enables cross-platform control
over PCs and USB-based computers including USB Sun™ workstations and
Mac® computers.
Feature Overview
Enhanced Security
Directly routes input and output signals to each individual computer,
preventing unintended information exchange.
Hot Keys
Hot key functionality allows you to select a desired port using designated
key commands. By using a simple hot key sequence on your keyboard,
selecting one computer from as many as 16 computers is instantaneous. For
a listing of complete hot key instructions and commands, see page 18.
AutoScan
The AutoScan feature allows you to set your Switch to scan and monitor
the activities of all operating computers connected to the Switch—one
by one. The time interval allotted for each computer is 10 seconds. For
complete instructions on AutoScan usage, please refer to page 20.
Video Resolution
Through a 400MHz bandwidth, the Switch supports video resolutions of
up to 2048x1536@85Hz. To preserve signal integrity at these higher
resolutions, your Switch requires 75-Ohm coaxial VGA cabling.
Flash Upgrade
Flash-upgradeable firmware allows you to obtain the latest firmware
upgrades for your Switch. This enables your Switch to maintain consistent
compatibility with the latest devices and computers. Firmware upgrades
are free for the life of your Switch. Refer to the flash upgrade instructions
on page 20 or visit us at belkin.com for complete upgrade information
and support.
2
OVERVIEW
Direct-Access Port Selectors
Direct-access port selectors, located conveniently on the front face
of the Switch, allow for simple, manual port-selection. Each button
controls a port. The BANK scroll buttons located on the front panel
of the Switch let you select daisy-chained switches. Each scroll
button corresponds to a daisy-chained switch. You can add more
ports to your KVM configuration by connecting SE Plus Series KVM
Switches, up to a maximum total of four switches to support as
many as 16 computers.
LED Display
An LED display on the face of the Switch serves as a status monitor. An
LED next to each direct-access port selector lights to indicate that the
console currently controls the corresponding computer. As a port selector
is pushed, the LED next to it will light up. A flashing port LED indicates
that there is no computer connected to that port.
7-Segment LED Display
When daisy-chaining multiple KVM Switches together, the 7-segment LED
display serves as a quick indicator of the selected BANK.
3
Advertisement
Table of Contents
