Table of Contents
Advertisement
Call functions
Pause dialing
When you call an automated system, like a
banking service, you are often required to enter a
password or account number. Instead of manually
entering the numbers each time, you can store
the numbers in your Contacts, separated by
special characters which are called pauses.
There are two kinds of pauses that can be entered
on your phone:
• Hard pause: A hard pause stops the dialing
sequence until you press
.
• 2-second pause: A two second pause stops the
dialing sequence for two seconds and then
automatically sends the remaining digits.
Note: Multiple two second pauses can be entered to
extend the length of a pause. Keep in mind
that pauses count as digits towards the 32
digit dialing maximum.
Storing pauses in a contacts entry
To store a number in your Contacts that contains
pauses:
1. Enter the phone number you want to store,
such as the bank's teleservice phone number.
2. Press the Menu soft key to access the options.
3. Select the required pause type and press the
OK key.
• Press
for Hard pause. The letter "P"
displays, meaning that a hard pause will
occur at that point in the dialing sequence.
32
• Press
for 2sec pause. The letter "T"
displays, meaning that a "Timed" pause will
occur at that point in the dialing sequence.
4. Enter the digits that need to follow the pause,
such as your account number.
5. Repeat steps 2 through 4 to add more pauses
and numbers, if necessary.
6. Store the number in your Contacts as you
normally would by pressing
soft key and following from step 2 on page xx.
Pause dialing from a stored contacts
entry
1. Dial the number of the service from Contacts.
2. If you stored the number using a hard
pause(s), wait for the appropriate prompt from
the number you are calling. When prompted,
press
to send the DTMF (Dual tone multi-
frequency) number that follows your pause.
If you stored the number using a two second
pause(s), your phone transmits the number
that follows the "T" pause two seconds after
the connection.
3. "Sending DTMF" flashes on the display and the
transmitted tone sounds.
4. Repeat from step 2, if necessary.
Call functions
or the Save
33
Advertisement
Table of Contents
