Setup - General UV254SD User Manual

SETUP

1. Choose the power source. Before using the UV254SD, be sure it is powered by fresh
batteries or an optional 9VDC AC adapter plugged into the bottom jack on its right side
(callout 1-12).
To remove the battery compartment cover, remove the two screws holding it in place
(callout 1-14). Then install six "AA" batteries in the correct orientation, using the polarity
marks on the inside of the compartment as a guide. Replace the cover by replacing the
two screws.
2. Install an SD card. To prepare for setup, also install the supplied 2 GB SD memory card
or another card with a capacity from 1 GB to 16 GB in the socket on the bottom of the
UV254SD (callout 1-9). When installing the card, make sure its gold contacts are facing
front and push the card into the socket until you hear a click. To remove the card, push it
in until you hear a click and the card pops out.
Now power on the instrument by pressing the POWER/ESC button (callout 1-2) to generate
a short beep. (To power off the UV254SD, press the POWER/ESC button and hold it until the
instrument responds with a long beep.)
When the meter powers on, a series of transient startup screens will briefly appear. Once
the display has stabilized, perform the following eight setup steps in the order presented.
3. Set the date and time. Press the SET M button (callout 1-5) and hold it for at least five
seconds, until "SEt dAtE" appears on the display. Quickly (within three seconds) press
the REC/ENTER button. The word "dAtE" will appear in the center of the display, along
with the flashing value "00.00.00" at the lower left, above "yy.mm.dd".
(If you press buttons too slowly in setup mode, the screen will revert to the normal display.
To return to the setup sequence, press and hold the SET M button again. To move ahead to
the next field in the sequence or to the next parameter, press the FUNC./HOLD/NEXT button
(callout 1-3).)
Set the current year by pressing the SET M or LOGGER
correct value appears above "yy". Quickly (within three seconds), press the REC/ENTER
button to store the setting. The next screen that appears will have the value above "mm"
flashing. Use the SET M or LOGGER
the REC/ENTER button to store the setting. When the next screen flashes the value above
"dd", again use the SET M or LOGGER
the REC/ENTER button to store the setting.
Once you have set the date, the display will prompt you to set the hour, minute and second
of the current time. Again use the SET M or LOGGER
values, and the REC/ENTER button to store the settings.
4. Choose a period or a comma to represent the decimal division between integers and
fractions (for example, American-style 20.88 vs. European-style 20,88). Press the SET
M button to make "bASIC" (American style) or "Euro" appear in the upper display, as
desired. Press the REC/ENTER button to store the selection.
button to navigate to the current month and press
button to navigate to the current day and press
buttons to navigate to the correct
button repeatedly until the
5