Auto-Burst Function; Automatic Shut-Off Function - Philips SONICARE AirFloss Ultra User Manual

12
English
Note: The AirFloss Ultra remembers what mode was selected last
and it is ready for the next use. If your AirFloss Ultra becomes fully
drained of power, it will go back to the triple burst default mode
once it has been recharged.
2 Place the nozzle tip between two teeth at your gum line. Slightly
close your lips over the nozzle when it is in place, to avoid
splashing. (Fig. 13)
3 Press the activation button to deliver 1-3 bursts (depending on the
selected mode) of air and micro-droplets of mouthwash or water
between the teeth. (Fig. 14)
4 Slide the nozzle tip along the gum line until you feel it settle
between the next two teeth.
5 Continue this procedure for all spaces between your teeth,
including behind your back teeth. (Fig. 15)
Note: Refill the reservoir as needed.

Auto-burst function

Hold the activation button to deliver bursts continuously,
approximately one second between set of bursts.

Automatic shut-off function

The AirFloss automatically turns off if it has not been used for one
minute.
Cleaning
If the AirFloss Ultra becomes clogged, or to clean the inside of the
AirFloss, fill the reservoir with warm water and press the activation
button until the reservoir is empty.
Do not clean the nozzle, handle or charger in the dishwasher.
Do not use cleaning agents to clean the appliance. The formulation
or strength of some agents may damage the appliance.
Handle and nozzle
1 Remove the AirFloss Ultra nozzle from the handle. Rinse the
nozzle after each use to eliminate the residue left in it. (Fig. 16)