Connections; Connections Using Model 7169~Kit - Keithley 7169 Instruction Manual

SECTION 2
Operation
2.5 CONNECTIONS
CAUTION
Contamination will degrade the performance of the scan-
ner card. To avoid contamination, always grasp the card by
the side edges. Do not touch the board surfaces or compo-
nents.
Figure 2-4 shows the connectors on the scanner card. Table 2-l refer-
ences scanner card terminals to connector pins and channel numbers.
For example, Channel 1 common is connected to pin A of J102 and Chan-
nel 1 normally-open is connected to pin B of J103.
?
I
l- PC
Board
%wre 2-4. Connectors on Scanner Card (Pin Side Shown)
The connector on the scanner card will mate to either a connector
(Model 7169~KIT) or to an optional mass terminated cable (Model
7169-MTC-10).
The following procedure explains how to mate the connector to the
Model 7169.
1. Mate the female connector to the male connector on the PC board.
2. Tighten the jackscrew finger tight. This is the locked position and
secures the connectors together.
2.51 Connections Using Model 7169.KIT
The Model 7169-KIT is a connector that mates to the connector on the
back panel of the Model 7169. Cabling from instrumentation and DUTs
2-b