General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference; Additional Safety Rules For Tool - Makita LH1200FL Instruction Manual

Model LH1200FL 110V
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita Corporation
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Table Top Miter Saw
Model No./ Type: LH1200FL
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN61029
The EC Type-Examination Certificate No.BM 50198759
0001
The EC Type-Examination per 2006/42/EC was
performed by:
TÜV Rheinland LGA Products GmbH
Tillystraße 2, 90431, Nürnberg, Germany
Identification No.0197
) : 95 dB(A)
pA
) : 108 dB(A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
as the responsible
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
ENG900-1
000230
sum)
ENG901-1
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
ADDITIONAL SAFETY RULES
FOR TOOL
FOR BOTH MITER SAW MOGE AND TABLE SAW
(BENCH SAW) MODE
1. Wear eye and hearing protection. Other suitable
ENH039-2
personal protective equipment should be worn.
2. NEVER wear gloves during operation except
for replacing saw blades or handling rough
material before operation.
3. Keep the floor area around the tool level well
maintained and free of loose materials e.g.
chips and cut-offs.
4. Do not operate saw without guards and riving
knife in place. Check blade guards for proper
closing before each use. Do not operate saw if
blade guards do not move freely and close
instantly. Never clamp or tie the blade guards
into the open position. Any irregular operation
of the blade guards should be corrected
immediately.
5. Clean and be careful not to damage the
spindle, flanges (especially the installing
surface) and hex bolt before or when installing
the blade. Damage to these parts could result
in blade breakage. Poor installation may cause
vibration/wobbling or slippage of the blade.
Use only flanges specified for this tool.
8
14.7.2011
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
GEA010-1
ENB088-4